# hinv -vm
Location: /hw/module/001c01/node
IP34 Board: barcode MZK064     part 030-1707-003 rev -M
Location: /hw/module/001c01/Ibrick/xtalk/13
ASTODYV10 Board: barcode MZL917     part 030-1826-001 rev -B
Location: /hw/module/001c01/Ibrick/xtalk/14
IP34 Board: barcode MZK064     part 030-1707-003 rev -M
Location: /hw/module/001c01/Ibrick/xtalk/15
IP34 Board: barcode MZK064     part 030-1707-003 rev -M
1 600 MHZ IP35 Processor
CPU: MIPS R14000 Processor Chip Revision: 2.4
FPU: MIPS R14010 Floating Point Chip Revision: 2.4
CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled)
Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
Main memory size: 2048 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 2048 MB (enabled)
Bank 0 contains 512 MB (Standard) DIMMS (enabled)
Bank 1 contains 512 MB (Standard) DIMMS (enabled)
Bank 2 contains 512 MB (Standard) DIMMS (enabled)
Bank 3 contains 512 MB (Standard) DIMMS (enabled)
Integral SCSI controller 0: Version QL12160, low voltage differential
Disk drive: unit 1 on SCSI controller 0 (unit 1)
Disk drive: unit 2 on SCSI controller 0 (unit 2)
Integral SCSI controller 1: Version QL12160, single ended
CDROM: unit 6 on SCSI controller 1
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V10
Gigabit Ethernet: eg0, module 001c01, pci_bus 1, pci_slot 2, firmware version 12.4.10
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
PCI Adapter ID (vendor 4215, device 4630) pci slot 1
PCI Adapter ID (vendor 4265, device 9) pci slot 2
PCI Adapter ID (vendor 4265, device 3) pci slot 4
PCI Adapter ID (vendor 4165, device 51297) pci slot 5
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.210
USB controller: type OHCI

# gfxinfo -vv
Graphics board 0 is "ODYSSEY" graphics.
Managed (":0.0") 1280x1024
BUZZ version B.1
PB&J version 1
32MB memory
Banks: 2, CAS latency: 3
Monitor 0 type: ACR 515
Input Sync: Voltage - Video Level; Source - Internal; Genlocked - False
Channel 0:
Origin = (0,0)
Video Output: 1280 pixels, 1024 lines, 60.00Hz (1280x1024_60)
Video Format Flags:  (none)
Sync Disabled
Using Gamma Map 0
Monitor Type:  ACR-515
Gain (all color components) - 0.000000 ; range [1,10]